Heavy Duty Two Position Flat or 5 Deg Tilt Wall Mount for Samsung QN75Q80DAFXZA

---

Wall Mount Overview

This extra heavy duty tilting wall mount bracket fits Samsung QN75Q80DAFXZA 75" Q80D displays. It has two viewing positions, 5 deg downward tilt or 0 deg flat. Manufactured in the USA.

VESA compatible
Two positions flat or 5 deg downward tilt (no tools required)
Low profile 1.63"
Easy installation
16” - 24” - 32” wall stud mounting points
Lateral movement from center for better viewing position

Safety Checklist:
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow
Always install so that the load is supported by a wood stud.
Do not install on decorative posts or plaster board.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel display and the wall mount. Always use at least two persons for all installations. Fully tighten all of the mounting screws as specified in the installation instructions.