Home > TV Mounts that Raise/Lower >

Pull Down TV Wall Mount 46" - 65" with Tilt/Swivel

Pull Down TV Wall Mount with Tilt/Swivel
 
Alternative Views:


List Price: $459.99
Our Price: $399.99


Availability:: Usually Ships in 24 Hours
Product Code: ASM-LOWER-RAISE

Description
 
Tired of looking up straining your neck to watch TV. With our mount the strain is over. Designed for TVs 46" - 65" and that weigh less than 70 lbs this mount is the perfect choice. With this mount your LED, OLED, LCD or Plasma flat panel can be stored above chalk boards, fireplaces or overhead structure and when needed it can be pulled down by spring assisited cylinders for a more comfortable viewing experience. The mount features a circular motion instead of a linear motion. The circular motion allows the flat panel to move around the mantel so that a comfortable viewing position can be reached.

  • Lifts and lowers 27"
  • Adjust counter balance block to hold TV in place when released
  • 16.5 lb - 70 lb weight capacity
  • Depth from wall 4 3/4"
  • Max extension from wall 19"

Important Notes:
1. The bracket assembly is 28 1/4" tall If used for any TV which has height less than that the wall plate will show.

2. The TV must weigh between 16.45 - 70lbs. for the mount to operate properly. Do not purchase if you TV does not fall within the weight tolerances listed.



Special Notice: Wall Mount World nor the manufacturer takes no responsibility for damage caused from the fireplace or other heating sources to the television, mount, or other accessories. Damage could be done when the mount is down, out, or even up. It is up to the consumer to take the proper precautions to avoid damage. Electrical equipment can be overheated easier than expected. Wall Mount World and the manufacturer recommends against having fires in the fireplace whenever there is electrical equipment around.
Features
  • Fits most 55" - 65" flat panels
  • Stays in place in up position
  • Swings out and around obstacles that are 10" and less
  • Built in tension system
  • 27" travel with 4" obstacle depth
  • 20" travel with 8" obstacle depth
  • Swivel left right +/- 18 degrees
  • Tilt adjustment range +/- 15 degrees
  • Roll adjustment for leveling +/- 5 degrees
  • Profile from wall fully collapsed: 4-3/4"
  • Max extension from wall: 19"
  • Fully lowered depth from wall: 10"
  • Minimum weight required 16.5 lbs
  • Maximum weight capacity 70 lbs.
  • Attaches to two studs on 16" centers
  • Fits VESA sizes: 200x200 up to the maximum 600x400mm
  • Wall Plate dimensions: 17-3/4" W x 16-1/4" H
  • Mount assembly total height 28-1/4"
  • Wall Plate covers included
  • Assembly required


Share your knowledge of this product with other customers... Be the first to write a review