Extra Heavy Duty Two Position Flat - 5 Deg Tilt Wall Mount for 70" - 100" displays

Wall Mount Overview

This extra heavy duty wall mount bracket is for display sizes ranging from 70" to 100". It has two viewing positions, either flat or 5 deg tilt no tools required. It has a 400lb UL rated load capacity which is tested at 4X rated weight. The bracket has a slim profile from wall. VESA Ready. Manufactured in the USA. TAA compliant (Trade Agreement Act) for Government use.

Low profile 1.63"
Easy installation
16” - 24” - 32” wall stud mounting points
Flat or 5° tilt (no tools required)
Lateral movement from center for better viewing position

Safety Checklist:
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and airflow
Always install so that the load is supported by a wood stud.
Do not install on decorative posts or plaster board.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel display and the wall mount. Always use at least two persons for all installations. Fully tighten all of the mounting screws as specified in the installation instructions.